Posted by Mario Antonio Morselli on April 20, 2000 at 16:23:35:
In Reply to: request for nylon st. bevel gear standards posted by knv suresh babu on March 24, 2000 at 11:01:46:
You can find something in:
AGMA 141.01 AUG.1984
AGMA information sheet
Plastic Gearing - Molded, Machined, and Other Methods.
For what I know DIN 6 is not possible with plastic gears: too accurate.
Usually plastic gears has also much more backlash becaus theeth diplacement need this.
For what I know Nylon is suitable for -30°C: you should use other plastic material.
Warmest regards.
Mario Antonio Morselli