Posted by Allan Guest on March 26, 2002 at 11:11:54:
In Reply to: Gleason no.16 Hypoid Gear Generator posted by Azher Shahzad on March 26, 2002 at 09:02:13:
Mr. Shazad
To determine whether the hypiod can be cut further information is required
1/ No of teeth in gear and pinion
2/ Hand of spiral on gear
3/Offset
4/Face Width
5/Mounting distance of gear & pinion
6/ Pitch circle diameter of gear
7/ Pressure angle
Once this information is Known then you can you can work out if it is within limits.
Allan Guest