Re: Calculating Gear Test Radius


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by Zachary Young on September 28, 2000 at 10:15:43:

In Reply to: Re: Calculating Gear Test Radius posted by James W. Lincoln on September 26, 2000 at 19:41:13:

To follow up my own question, I found the information I was looking for in ANSI/AGMA 2002-B88 Tooth Thickness Specification and Measurement (1988).In response to Mr. Lincoln's posting, as I understand it, the min. and max tooth thinning is multiplied by the tangent of the pressure angle, not the cosine.


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Optional Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]