Posted by BillS on December 01, 2009 at 10:03:58:
In Reply to: Re: Point Width of Heads (or Spread of Blades) posted by Tomasz_K on November 27, 2009 at 05:43:06:
Hi Tomasz,
Would you like to write an article for this website?
We don't get a visitor/contributor often with spiral blade manufacturing experience (you might be the first!),
and we would all appreciate any material that explains Gleason spiral blades and bodies.
If you can share with the community, I'll be more than happy to post it under Articles, and/or FAQ page
subject to your approval. You and your company will get full recognition of course.
Here is the link to articles:
Articles Section
and to the FAQ page:
FAQ Section
If you think of other topics that would interest the community, I welcome your suggestions.
In any event I hope you will visit often and offer assistance as you are able.