Re: Barber Coleman No. 3 question


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by Mike on April 18, 2012 at 12:39:29:

In Reply to: Barber Coleman No. 3 question posted by ESteiner on April 17, 2012 at 11:36:02:

The feed ratio should be on the plate attached to the feed gear box which lists the change gears for desired feed (unless your plate is missing). On my 24/N machine, single index machine it is .150 (plate says............ "feed required /.150" )
Does your machine have this plate? what are you cutting? a spur or helical gear? I can give you what my machine has for the feed gears for various feeds listed on the plate.
my email: cardinaleng@sbcglobal.net


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]