Posted by lbmakem on July 19, 2009 at 09:44:55:
In Reply to: Re: Stop on Fellows 6A gear shaper posted by Sean on July 17, 2009 at 16:12:24:
Its years since i used a 6A and don't believe you can, but a way around it (depending on the number of teeth in the job & the protrusion)was to grind away some of the teeth in the cutter leaving sufficient to cut the number of teeth required and no more,you then have to stop the cutter each time and wind back to the start position, this is ok if you are only doing a small batch of gears but not practical for a large batch.