Re: TILT angle setting for No.7a


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by Don P on November 08, 2012 at 09:25:26:

In Reply to: TILT angle setting for No.7a posted by Azhar Shahazd on November 04, 2012 at 02:15:27:

I assume, from your question, that you have
you already have settings or a program for
calculating settings for the 16 generator.If this the case, then it's very easy.
Tilt angle 7A = tilt angle 16 when tilt angle 16
is greater than zero.
When tilt angle 16 is less than zero (i.e.358*45') then tilt angle 7A = 360* - tilt angle 16.
Figure gear and pinion both by this method, it's
not like the 16 gen in that you will end up with
the same tilt 7A for both members.
I hope this helps.
Dogballz99


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]