Posted by Zahnrad Kopf on April 09, 2019 at 17:46:05:
In Reply to: Gear Shaping Cutter Design posted by Zahnrad Kopf on April 09, 2019 at 13:08:31:
To update - This has gained some steam in little time. It's looking very good and we may actually end up doing this. There are basically two details remaining to sort, but I just found out that an old friend has been fairly well immersed in this subject for much of his life, so I am confident that if push comes to shove ( and some valuable input from my friend ) we would be able to pull this off for the customer.
Otherwise, if someone knows of some place that will make QUALITY custom shaper cutters in less than 6-8 weeks, do let me know as I would still prefer to purchase them and go down this particular rabbit hole in leisure, rather than pressured.
Post a Followup